well since trp is the best animater around here

i was hoping you could help me out with fixing this little animation problem :P

i was bored and started making a gerbal running thingy to replace the mill under the bridge on anzio :p :D but when i compile it the animation doesnt play :confused:

also if you could maybe help me out with adding a animation for the dod bunny or a rat to run in it :p :D that would be sweet

p.s. yes im that bored with dod that im making this lol

p.s.s. i hant played dod for months :eek:

Errr, I'm not that good an animator...

And your questions are too vauge to give a proper answer.

- Jed

:o ok i compiled the new model with the existing mill bones and when i open it up in hlmv the animation doesnt play. the original mill turns slowly. what did i do wrong ?

also would it be possible for me to add another animation for a rodent like the bunny or a rat to look as if it it running on the wheel ?

is that better now:confused: :D :D :D

hmmm :/

Bit busy old chap...

Off to the other side of Sweden tomorrow.
I'll get back to you later, or someone else can feel free to step in.

- Jed

If your going to want to add a gerbil in the wheel start from scratch.

The wheel itself only needs one bone with all vertices attached and just needs to be rotated for the animation sequence.

To add a moving gerbil you'll need to add a skeleton for it with leg bones, etc. and adding that into a pre-exisiting anim is no easy task without seriously messing stuff up.

As I said, best bet is to use one bone for the wheel and make and animate a hamster skeleton as part of it.

- Jed

lol heres my first animation :D

i guess i better find another job lol

if you can find it in your heart to suggest what i should do next i would be a happy camper :)

i would really like to get good at animating :)

The model is an animation? I thought it was on a func brush or something.